If not, the cursor will just move to the other monitor since it is not "blocked". This works for vertically stacked monitors as long as there is some place where the cursor is "blocked". The dock will be "summoned" to this monitor from the other monitor. Once the cursor is "blocked", pause a sec, then continue the motion downward. this doesn't work on vertically stacked monitors along the area where the cursor can cross between screens. The target area of the cursor needs to be at the bottom area of the monitor which doesn't currently have the dock at a place where the cursor can't move further down, i.e. (When people say "drag" the mouse, that usually implies with the mouse button held down.) This is what worked for me.ĭon't hold the mouse button down. ![]() Follow the steps below and by the time you are done, the finder will hopefully be working.The action that summons the dock to the opposite monitor is not very intuitive for me. This will start the reinstallation process. Now from the same menu, click on Reinstall macOS. Also, choose Mac OS Extended (Journaled) as the format when asked. Now, you have to select the startup disk (the disk where Mac is installed). When the option comes, click on Disk Utility.First, you have to restart in Recovery Just restart your Mac and when the computer powers back on, press and hold the Command + R keys until the Apple logo is visible.Only you are done with the backup and saving of configuration files of applications on the cloud, should you only proceed. Here, it is recommended that you save all your files and folders beforehand as they will get erased when we clear your storage. If all the above methods don’t work out, it probably means there are some issues with the internal files/folders which we cannot access and restore the Mac to factory settings is the only way to get the Finder back up and running again. ![]() Solution 8: Resetting Mac to Factory Settings After the computer starts up, you can navigate to your settings and see if it was of any good.In other Mac computers where there is Apple T2 Security Chip, you can release the keys after the Apple Logo appears and disappears the second time. When you hear the second startup sound, release the keys. In some Mac computers, you will hear a startup sound the second time (the first time will come when you just opened your Mac before pressing the keys). Now there are two scenarios where you have to release the keys: During this time, your Mac will appear to start. Wait for around 20-30 seconds before releasing all the keys.Now when you turn it back on, you need to press the following keys at once together: ![]() Note: In some cases, some temporary or customizable configurations will be lost so make sure you know how to revert them. All your configurations are stored here and if there is any issue in them (they are corrupt or incomplete), we can try resetting so all everything is set to default. PRAM (Parameter RAM) is basically the same thing and both memories can be reset using the same method. NVRAM (also known as Non-Volatile Random-Access Memory) is a small block of memory which is used by your Mac computer to store specific settings so it can access them later on. ![]() Also, save all your work beforehand as we will be restarting your computer again and again. Disabling the magnification might solve the issue at hand.īefore we start with the solutions, make sure that you have an active internet connection on your computer and are logged in as an administrator. This feature is known to sometimes cause various bugs and issues.
0 Comments
Leave a Reply. |